Wheatstone Bridge
Wheatstone Bridge: Overview
This topic covers concepts, such as Wheatstone Bridge, Balanced Wheatstone Bridge, and Unbalanced Wheatstone Bridge.
Important Questions on Wheatstone Bridge
The current drawn from the battery in the given network is

The magnitude of resistance in the circuit shown in the given figure, when no current flows through the resistor is

The percentage error in measuring resistance with a meter bridge can be minimised by adjusting the balancing point close to

The equivalent resistance of the circuit shown below between points and is :

The equivalent resistance between the points and is:

In the circuit shown, equivalent resistance between and is:

A battery of is connected to the circuit as shown below. The current drawn from the battery is

The current in the given circuit will be

B shaped circuit is made of equal resistances , the equivalent resistance across AC is

The four impedance of a.c. bridge shown below are . Determine the value of impedance , such that the bridge is balanced.


In the following circuit, the effective resistance between the points and is

In comparing the resistance of coils and with a slide wire bridge, a balance point is obtained when the sliding contact is from the zero end of the wire. The resistances and are interchanged and the balance is obtained at from the same end. The length of the bridge wire is

A balanced Wheatstone bridge shown in the figure. If the positions of the cell C and the galvanometer G are now interchanged, G will show zero deflection.

Six equal resistances each 1Ω are joined to form a network as shown in the figure. Then the resistance between any two corners is

What is the total resistance across A and B in the circuit shown in figure?

Figure shows an unbalanced Wheatstone bridge. What is the direction of conventional current between and ?

The figure given below shows a network of eight resistors, each equal to connected to a battery of negligible internal resistance. The current in the circuit is

Find the equivalent resistance between and .

The current drawn from the source will be
